Serving the League City area  ·  (832) 957-9153  ·  Open Mon-Sun 7am-7pm
📞 (832) 957-9153 Free Quote

Metal Roofing in Webster, TX (77598) · Local Professionals

League City Metal Roofing · Fast response in Webster and the League City area · Free estimate 24h

✅ Licensed Contractor 🛡️ Licensed & Insured 💸 Free Quote 24h 🕐 Mon-Sun 7am-7pm
+142Verified Reviews
10Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Licensed & Insured

Webster is the kind of town where a 1975 brick ranch off NASA Road 1 can sit two streets over from a newer townhome near Clear Lake. The lots are tight, the live oaks are old, and the afternoon thunderstorms come in fast off the bay. If your shingle roof has been patching along since the Reagan years, you are not alone.

Homeowners in Webster (77598) call League City Metal Roofing because we know this housing stock. We have replaced plenty of aging composition roofs near the Clear Creek corridor and worked around the HOA rules that pop up in the townhomes closer to NASA Parkway. We are based just down the road in League City, fully insured, and we show up when we say we will.

Metal Roofing in Webster (77598)

Webster sits on the same flat Gulf Coast prairie as League City, only about 15 feet above sea level, with heavy clay soil that holds water after a big rain. That matters for roof work. We are often dealing with tight side yards where a dumpster has to go in the driveway, low-hanging live oak and pecan branches that scrape panels during delivery, and older 1970s ranches where the decking has taken on moisture for decades. The salt air from the bay is close enough that bare steel fasteners will start to corrode if they are not the right grade, so we use coated or stainless fasteners on every metal roof we install here. The humid heat is the other factor. Attic ventilation and proper underlayment matter as much as the panels themselves, especially on the low-slope porches and carports common in the older neighborhoods.

Our team has worked across Webster and the surrounding League City area long enough to know which streets have the tightest access, which HOAs want a specific panel profile, and which older homes need a decking inspection before we talk about a retrofit. We handle metal roof installation, replacement, repair, and the retrofit over existing shingles when the decking and code allow it.

Our services in Webster

How a Job Works in Webster

Step 1: You call (832) 957-9153 or reach out through the site. We schedule a free on-site assessment, usually within a couple of days. We get on the roof, check the decking, flashing, and fasteners, and take photos. You get a written estimate with the scope and the price, not a ballpark over the phone.

Step 2: Once you approve, we pull the permit through the local building department and coordinate any HOA design review if your subdivision requires it. On the work day, we protect your landscaping and driveway, stage materials as close as the lot allows, and keep the crew moving. On the older ranches near NASA Road 1, that often means planning panel delivery around low branches and a narrow driveway. We keep you posted on progress and anything we find once the old roof is off.

Step 3: Cleanup is part of the job. We magnet-sweep the yard and driveway for nails, haul away the old material, and walk the finished roof with you. You get a final look at the seams, flashing, and gutters before we pack up.

Pricing in Webster depends on the size and pitch of your roof, the condition of the decking, access around the house, and how soon you need it done. For a typical Webster ranch or townhome, metal roof installation starts around $8 per square foot, standing seam starts around $10, metal roof replacement starts around $9, and a retrofit over existing shingles starts around $7 when the code and decking allow it. Smaller jobs are common here too: metal roof repair and leak repair start around $450, screw replacement and re-fastening start around $750, and flashing, chimney, or skylight repair starts around $600. Coating and painting start around $2.50 per square foot if your existing metal roof just needs a refresh. We give you a free estimate with real numbers for your roof, not a range that changes later. Call (832) 957-9153 to set it up.

My 1970s ranch near NASA Road 1 has two layers of shingles. Can you still do a metal roof over shingles in Webster?
Sometimes, but it depends on the code limit for existing layers and the condition of the decking underneath. We inspect the roof first. If the decking is soft or the layers are already at the limit, a full tear-off and replacement is the safer call. We will tell you straight which one your house needs.
A storm just peeled back panels on my metal roof in Webster. How fast can you get out?
We treat wind-lifted panels and active leaks as priority calls. Call (832) 957-9153 and we will schedule the soonest available inspection, often same day or next day depending on storm volume. We can usually secure the roof temporarily before the permanent repair.
What does a metal roof replacement cost for a typical Webster townhome or ranch?
Most Webster homes land somewhere between the low thousands and the mid teens depending on square footage, pitch, decking condition, and panel type. Replacement starts around $9 per square foot and standing seam starts around $10. We give you an exact written estimate after the free inspection.
Do I need a permit for a metal roof in Webster, and does the city inspect it?
Roofing permits are commonly required for a full replacement or re-roof in Webster, and the thresholds and inspection requirements can vary. We pull the permit and coordinate the inspection as part of the job. Always confirm the current rules with the local building department, since they can change.
My HOA wants a specific panel color and profile. Can you handle that approval?
Yes. Several townhome and subdivision HOAs around Webster have design review rules for roof profile and color. We help you submit the right product information and wait for approval before ordering materials, so there are no surprises on install day.
Are you insured for work on my Webster property?
We are fully insured with general liability and workers' compensation coverage.
What maintenance does a metal roof need in Webster's humidity and storm season?
Check fasteners and seam condition once a year, especially after a named storm. Clear debris from valleys and gutters so water does not sit against flashing. In this salt air, coated or stainless fasteners matter, and a coating refresh every several years can extend the life of an older metal roof. We offer free inspections if you want a professional look.
Why choose us?

Trusted professionals in League City

🏅

Licensed contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Licensed & Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sun 7am-7pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Metal Roofing Services in League City

All your work handled by qualified professionals in League City

Metal Roof Installation

Complete metal roof systems engineered for your local climate and built to outlast three shingle roofs.

Included in your service

  • Deck inspection and repair before any panel goes on
  • High-temp synthetic underlayment and correct ridge and soffit ventilation
  • Manufacturer-certified panel, trim, and flashing details for the full warranty
  • Free on-site assessment and written estimate within 24h
Learn more→

Standing Seam Metal Roofing

Concealed-fastener standing seam: no exposed screws to loosen, leak, or need re-torquing.

Included in your service

  • Panels roll-formed to the exact length of your roof, no end laps
  • Mechanically seamed or snap-lock profiles with concealed clips
  • Floating clip system that lets panels expand and contract freely
  • Kynar 500 / PVDF finish in the full architectural color range
Learn more→

Metal Roof Replacement

Full tear-off of an end-of-life shingle, cedar, or metal roof, replaced with a complete new system.

Included in your service

  • Tear-off and haul-away of the old roofing, dumpster included
  • Decking inspected board by board, rot and soft spots replaced
  • New underlayment, drip edge, valleys, and penetration flashing throughout
  • Documentation of the finished system for your insurer or future buyer
Learn more→

Metal Roof Over Shingles (Retrofit)

Retrofit metal installed over sound existing shingles: no tear-off, less waste, lower cost.

Included in your service

  • Honest deck and shingle assessment first, recover only when it is the right call
  • Furring strips or slip sheet as the panel profile and local code require
  • Existing vents, pipe boots, and flashings reworked to the new roof plane
  • Straight guidance on when tear-off is the better long-term choice
Learn more→

Metal Roof Repair

Targeted repair of damaged, loose, or storm-hit metal roofing before it reaches your ceiling.

Included in your service

  • Bent, dented, or punctured panels replaced and color-matched
  • Seams, laps, and penetrations resealed with compatible butyl and sealant
  • Failed pipe boots, closures, and ridge cap fasteners renewed
  • Written findings with photos of what we found and what we fixed
Learn more→

Metal Roof Leak Repair

Priority leak response: we trace the leak to its real source instead of caulking the symptom.

Included in your service

  • Water testing and interior tracing to find the true entry point
  • Backed-out fasteners, separated seams, and flashing gaps corrected at the cause
  • Emergency tarping available same day after a storm
  • Attic and insulation moisture check so hidden damage does not sit and spread
Learn more→

Screw Replacement & Re-Fastening

The top cause of leaks on 15 to 30 year old screw-down roofs, fixed for a fraction of replacement.

Included in your service

  • Every fastener replaced with oversized screws and new EPDM sealing washers
  • Dried-out washers and stripped holes addressed panel by panel
  • Ridge, eave, and sidewall closures renewed at the same time
  • Restores a watertight roof without replacing sound panels
Learn more→

Corrugated & Ribbed Panel Roofing

Corrugated, tuff-rib, and 5V panel roofing: the budget-friendly workhorse for homes and outbuildings.

Included in your service

  • Galvalume and painted steel panels cut to length on site
  • Correct screw pattern and torque so washers seat without over-driving
  • Foam and metal closures at ridge, eave, and rake to keep weather and pests out
  • Full color range for homes, cabins, barns, and workshops
Learn more→

Metal Shingle Roofing

The look of architectural shingle, slate, or shake with the lifespan and wind rating of steel.

Included in your service

  • Interlocking stamped steel or aluminum shingle panels
  • Walkable finished surface, easier to service than a standing seam field
  • Lightweight enough for retrofit over an existing roof structure
  • Profiles and colors that suit historic and HOA-governed neighborhoods
Learn more→

Stone-Coated Steel Roofing

Steel strength under a textured stone finish, with strong hail and wind performance.

Included in your service

  • Acrylic-bonded stone granule surface over structural steel
  • Battened or direct-to-deck installation depending on the profile
  • Class A fire rating and high impact resistance ratings
  • Tile, shake, and shingle textures for suburban and coastal homes alike
Learn more→

Copper & Specialty Metal Roofing

Copper, zinc, and aluminum for porches, bay windows, dormers, and full architectural roofs.

Included in your service

  • In-house fabrication of pans, valleys, and custom curved details
  • Soldered seams and joints where the detail calls for it
  • Isolation of dissimilar metals to prevent galvanic corrosion
  • A living patina that develops over decades of service
Learn more→

Metal Roof Coating & Painting

Restoration for faded, chalking, or surface-rusted metal, adding 10 to 15 years without replacement.

Included in your service

  • Wash, degrease, and mechanical prep of the entire panel surface
  • Rust treatment and primer on affected areas before topcoat
  • High-performance elastomeric or silicone coating system applied to spec
  • Honest assessment first: we say so when the roof is past coating
Learn more→

Flashing, Chimney & Skylight Repair

Flashing is the number one leak point on any metal roof, and it is what we fabricate best.

Included in your service

  • Custom bent step, counter, and apron flashing made in-house
  • Chimney crickets to shed water on the uphill side
  • Skylight curbs and head flashing rebuilt to the panel profile
  • Valley and wall transition details closed with matching trim
Learn more→

Snow Guards & Ice Protection

Snow retention that stops rooftop avalanches onto decks, gutters, walkways, and entryways.

Included in your service

  • Pad-style guards or continuous rail systems matched to your panel
  • Layout calculated from roof pitch, panel length, and local snow load
  • Clamp-on mounting on standing seam, no panel penetrations
  • Ice dam and eave detailing for higher-elevation homes
Learn more→

Storm & Wind Damage Repair

Wind, hail, and fallen-limb repair with thorough documentation and a straight repair-or-replace answer.

Included in your service

  • Free post-storm inspection with dated photo documentation
  • Emergency tarping and temporary weatherproofing when needed
  • A written report you can use when documenting your insurance claim
  • Honest assessment of repair versus replacement, with no pressure either way
Learn more→

Metal Roof Inspection

A written, no-obligation assessment of fastener condition, seams, flashing, and remaining service life.

Included in your service

  • Fastener, washer, and seam condition checked across the field
  • Flashing, penetrations, and closures inspected point by point
  • Coating wear, chalking, and corrosion graded panel by panel
  • Written report with photos and a straight answer on years remaining
Learn more→

Gutters for Metal Roofs

Gutters sized and hung correctly for metal roofing, where standard hangers and spacing do not work.

Included in your service

  • Seamless aluminum or half-round systems formed on site
  • Hanger placement and spacing matched to the panel profile
  • Oversized capacity and downspouts sized for heavy regional rainfall
  • Bracket spacing tightened for high-wind zones so storms do not tear the gutter off
Learn more→

Commercial & Agricultural Metal Roofing

Barns, workshops, churches, and light commercial metal roofing across the county.

Included in your service

  • Long-run panels for wide spans and low-slope structures
  • Purlin and framing attachment detailed for the building type
  • Insulation, vapor barrier, and condensation control options
  • Repairs and re-fastening for aging agricultural metal buildings
Learn more→
Verified client reviews

142+ Verified Client Reviews in League City

⭐⭐⭐⭐⭐ 4.9/5 · 142 verified Google reviews

Free Quote

Get Your Free Quote

Metal Roofing in League City · Response within 24h · No commitment · ☎ (832) 957-9153

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Licensed & Insured 📍 On-site visits included in League City ✅ No hidden fees 🕐 Available Mon-Sun 7am-7pm